Stake Out Function - TOOLCRAFT LDM 70 P Mode D'emploi

6. Push the button ON to measure the second side length. The second
side length is measured continuously. The minimum measurement
is shown in the second line, the real-time measurement is shown
in the bottom line.
7. Push the button ON to register the minimum measurement of the
second side length.
8. Activate the target laser by pushing the button ON.
9. Push the button ON to measure the third length. The measurement
is shown in the third line.
10. The height between points 1 and 3 is calculated automatically and is
shown in the bottom line.

18. Stake out function

1. Push the button FUNC (L) six times. The display shows the following
elements:
2. Push the button + (K) to select one of the digits in the bottom line.
The selected digit flashes.
3. Push the button - (E) to change the digit value.
4. After you have set the desired distance, push the button ON (C) to
confirm. Then, the target laser (B) activates and the device changes
to continuous measurement mode. The distance you just set is
shown in the middle line, the real-time measurement is shown in
the bottom line.
49