Hettich EBA 280 Mode D'emploi page 67

5.4 Switching the centrifuge on and off.
Switching the centrifuge on
Switching off the centrifuge
6 Operation
6.1 Opening and closing the lid
Opening the lid
Closing the lid
AB1101en
Personnel:
■
Trained user
Set the mains switch to
�� The buttons flash, depending on the centrifuge type.
The following indicators appear one after the other, depending on
the centrifuge type:
■
the centrifuge model
■
the machine type and program version
■
the rotor code (R) and the maximum speed (maxRPM) of the
last rotor recognised by the rotor detection
■
When the lid is closed: For centrifuges with cooling,
lid' indicator. The lid opens in centrifuges without cooling.
■
When the lid is open: The centrifugation data of the last pro-
gram used or program 1.
The rotor is stationary.
Set the mains switch to
Personnel:
■
Trained user
The centrifuge is switched on.
The rotor is stationary.
[STOP/OPEN] button.
Press the
�� The lid unlocks by means of a motor.
'Lid unlocked' indicator appears.
The
CAUTION
Crushing hazard when closing the lid.
Danger of fingers getting crushed when the closing motor
pulls the lid against the seal.
−
No parts of the operator's body should be in the hazard
zone of the lid when closing the lid.
−
To close the lid, press on the lid from above.
NOTICE
Damage to the device caused by the lid slamming.
−
Close the lid slowly.
−
Do not slam the lid.
Personnel:
■
Trained user
Rev.: 07 / 10.2023
[I] .
[0] .
Operation
'Open the
19 / 44