Safety Precautions - StarLab N2631-0017 Mini Fuge Plus Mode D'emploi

3

Safety Precautions

NEVER use the centrifuge in any manner not specified in these instructions.
NEVER operate the centrifuge without a rotor properly attached to the shaft.
NEVER fill tubes while they are in the rotor. Liquid spillage may harm unit.
NEVER put hands in the rotor area unless the rotor is completely stopped.
NEVER move the centrifuge while the rotor is spinning.
NEVER use solvents or flammables near this or other electrical equipment.
NEVER centrifuge flammable, explosive or corrosive materials
NEVER centrifuge hazardous materials outside of a hood or proper containment facility
NEVER try to continue operating the centrifuge if the centrifuge stops working prematurely.
Stop the centrifuge immediately by turning off the main power switch on the back of
the centrifuge. Wait one minute before turning on the main power switch to operate the
centrifuge again.
ALWAY S load the rotor symmetrically. Each tube should be counterbalanced by another tube.
Weight of individual tubes may not exceed of 3.0 g.
ALWAYS locate the centrifuge within easy access to an electrical outlet.
ALWAY S use only micro centrifuge tubes made from plastic and designed to withstand
centrifugal forces of at least 2,000 x g.
If the centrifuge is used in a manner not specified by the manufacturer,
the protection provided by the centrifuge may be impaired.
5
Mini Fuge Plus · Manual ·