Removing The Tipone ® Repeat Dispenser Tip; Safety Precautions And Operational Limitations - StarLab RepeatOne Mode D'emploi

3.4. Removing the TipOne Repeat Dispenser Tip
®
(Fig. 8)
– Hold the RepeatOne over a beaker.
®
– Slowly depress the filling lever down to the stop.
This will completely empty the TipOne
Dispenser Tip.
– Raise the locking clamp upward.
– Remove the TipOne ® Repeat Dispenser Tip.
Note: When using the 25 ml or 50 ml TipOne
Dispenser Tips, the reusable adapter is removed by turning
it counter clockwise.
® Repeat
® Repeat
Fig. 8

4. Safety Precautions and Operational Limitations

When removing TipOne
note the following:
– Do not touch the tip end, especially when using
– Empty the dispenser tips into a proper discard
– Treat any retained fluid as a bio-hazard. Do not allow
– If dispensing a liquid with a surface tension significantly
– The RepeatOne
9
® Repeat Dispenser Tips, please
hazardous reagents!
receptacle to avoid splashing and aerosols.
the fluid to come into contact with laboratory personnel.
different from water, inaccuracies or leaking can occur.
with an attached, partially filled
®
TipOne ® Repeat Dispenser Tip should be stored in a
stand to prevent air entering the dispenser tip.