Pipette Identification; Safety Notes - StarLab Ergo One Mode D'emploi

2.4 Pipette Identification

Your pipette is supplied with autoclave-
resistant stickers in four different
colours. These can be attached to the
surface above the finger rest to person-
alise/help identify your pipette (Fig. 2).
Each ErgoOne pipette has its own
®
serial number. This serial number can
be found behind the tip ejector button
when it is pressed down.
2

2.5 Safety Notes

– Use the pipette only with tip(s)
– Make sure that no liquid enters the
– Do not lay the pipette down when a
– Do not set the volume outside the
– Do not use any aggressive solvents
– Do not use cleaning agents in
– Only use original parts and
– Before pipetting aggressive
– Avoid temperature differences
Fig. 2
– Check the dispensing volume of
attached.
pipette.
pipette tip is fixed and contains liquid.
specified range.
or acetone to clean the pipette.
combination with autoclaving or UV-
Treatment.
accessories.
chemicals or organic solvents, check
their compatibility with the pipette
and pipette tips.
between the pipette and pipette tip
as this could lead to incorrect
volume dispensing.
liquids that strongly differ from the
physical properties of water, eg.
with different density (see also
section 6 Calibration).
ErgoOne · User Manual ·
7