Arneg Aspen 2 MAXI Manuel D'utilisation page 36

Aspen 2 Maxi
English
1. Instructions for assembly of the Aspen 2 Maxi VCA superstructure
Attention!: Caution: Disconnect power to the cabinet before performing any operation.
Equipment necessary for assembly:
Screwdriver – Allen wrenches 2/3/4.
To assemble the superstructure for the Aspen cabinet, proceed as follows
1 Unpack
2 Place the upright of the superstructure in the
housing on the side of the cabinet.
3 Fasten carefully not completly the upright of
the superstructure to the housing on the side
of the cabinet..
4 A - Insert the U-shaped profile on the
longitudinal edge of the curved front glass.
B - Apply the polyurethane
gasket.
36
A
B
:
05060101 00 16/06/2009