GYS GYSPRESS 10T Mode D'emploi page 37

WORKSTATION GYSPRESS 10T PP CONTROL
ANOMALIES, CAUSES, REMEDIES
The table below shows the possible issues that can be encountered when using the tool. If the problem encounte-
red is not listed in the table below, stop using the tool and contact your dealer immediately to find the procedure to
follow.
Issues
The riveter is not working
The rivet is not positioned correctly
Air, sealing fault causing leakage
CONDITIONS OF WARRANTY
The warranty covers any manufacturing defect or general defect for two years from the date of purchase (parts and
labour). The warranty excludes incidents due to misuse, dropping, dismantling or any other damage due to transport.
The warranty does not cover the normal wearing of parts. Only spare parts from GYS should be used to carry out a
repair on the GYSPRESS 10T PUSH PULL riveter.
In the event of a fault, return the device to your distributor enclosing:
- dated proof of purchase (receipt or invoice, etc.)
- a note explaining the breakdown
TECHNICAL SPECIFICATIONS
The air network's max. pressure
Supply voltage range
Power supply to the machine
Maximum clamping force
Riveting machine weight
Product weight when empty
CAUSES
The compressed air is not connected
Mains power is not connected
Compressed air is not
correctly set up
Lack of oil
Defective mandrel or die
The die is not suitable
The pressure force is not suitable
Wrong rivet length
Defective hose
Defective coupling
Defective seal
SOLUTIONS
Connect compressed air
Connect the mains supply
Adjust the compressed air to 7 bar
Check that the riveter
is sufficiently filled with oil
Replace mandrel or die
Replace mandrel or die
Adjust the pressure force
Follow the instructions
the manufacturer;
Replace air hose
Replace coupling
Have the part repaired by the manufacturer
10 bar - 145 psi
1 ~ 100-240 Vac 50-60 Hz
1.4 A (100 Vac) - 0.57 A (240 Vac)
100 kN
3.9 kg
54 kg
EN
37