GYS GYSPRESS 10T Mode D'emploi page 33

WORKSTATION GYSPRESS 10T PP CONTROL
RIVET BOX PROVIDED
The riveter is supplied with a box of 300 self-piercing steel rivets (RAP).
These trial rivets are provided for testing the riveter and should not be used
for automotive repairs under any circumstances.
SETTING UP SELF-PIERCING RIVETS
Ø 3.3 mm
When installing self-piercing rivets, check that the rivets are properly fitted. The dies must not be damaged as this could
make riveting a problem.
During each riveting procedure, it is imperative to ensure that the die, and not the rivet itself, is placed on the sheets
to be assembled. It is also important to ensure that the header die support is positioned on the sheets so as to form a
90° angle.
Ø 5.3 mm
90°
EN
33