GYS GYSPRESS 10T Mode D'emploi page 34

EN
WORKSTATION GYSPRESS 10T PP CONTROL
THE OUTCOME OF INSTALLING SELF-PIERCING RIVETS
PUNCHING AND CALIBRATING HOLES FOR FLOW-FORM RIVETS
To punch the sheet and calibrate holes, a specific die called a stripper is needed. This die makes it possible to retain the
sheet when the header die is brought back through the metal sheet.
If Flow-Form rivets are used, the metal sheets must be drilled beforehand to allow the rivet to be fitted. The aforemen-
tioned header die and die allow precise drilling as well as the calibration of Flow-Form rivet holes.
34