GYS GYSPRESS 10T Mode D'emploi page 27

WORKSTATION GYSPRESS 10T PP CONTROL
- Flow-Form rivet
- Flow-Form, flat-head rivet
- Self-piercing rivet
- Solid rivet
- Solid, flat-head rivet
- Rivet bushes
- Crimping pins
GENERAL LAYOUT
Set-point pressure force
Operating mode / Rivet
selected
UNATTAINABLE EFFORT
The GYSPRESS 10T PP continuously checks whether the compressed-air network's pressure is sufficient to reach the
set-point pressure displayed. A message is displayed on the screen when the pressure becomes insufficient.
Operation report
An operation report is displayed at the end of each riveting operation (set-point pressure, measured force, date, time,
operating mode or manufacturer and rivet size).
In the case of positioning the types of rivets listed below, a good or bad pictorial example is shown on the right-hand
side of the screen at the end of the operation, this indicates whether the set-point pressure has been reached or not.
- Flow-Form rivet
- Flow-Form flat-head rivet
- Self-piercing rivet
- Solid rivet
- Solid, flat-head rivet
- Rivet bush
- Crimping pin
Choosing the correct operating mode and rivet
Selected operation
The GYSPRESS 10T PUSH-PULL CONTROL machine is set up to fit
GYS Ø 3.3 mm x 3.5 mm self-piercing rivets.
The target force is displayed on the left-hand side of the screen. Here
it is pre-set to 50 kN. The left dial can be used to adjust this target
force as desired.
To access the general menu, press button 1
To change the operating mode or rivet type, press button 2.
• Displayed on the LEFT are:
- the machine's operating mode or the rivet supplier
- the type of operations the machine can perform (riveting, drilling or
rivet removal, etc.)
-the type of rivet being used (self-piercing or Flow-Form, etc.)
-the size and type of the selected rivet
• The left dial is used to select one of these four fields
• Displayed on the RIGHT are the values which can be selected accor-
ding to the fields on the left
• The right dial is used to choose this value (which supplier, type of
operation, type of rivet and their part numbers)
EN
27