GYS GYSPRESS 10T Mode D'emploi page 35

WORKSTATION GYSPRESS 10T PP CONTROL
After punching, the header die is driven into the sheets metal.
The header die is removed and the sheet metal is prepared for
riveting.
If the punch does not come out of the sheet metal, use the
riveter's PULL function.
Press the PULL button and pull the trigger.
Once the header die is out of the sheet, press the PUSH button.
SETTING UP FLOW-FORM RIVETS
Before trying to assemble sheets using Flow-Form rivets, a pilot hole must first be created (see
process above).
Once the pilot hole has been made, insert the Flow-Form
rivet into it:
The F1 tip should be placed on the top of the rivet:
EN
35