Zehnder ComfoVar Aero Manuel D'installation Et D'entretien page 47

5.3 Removing/placing VM interior from/in VM
1. Loosen the clips (Fig. 5.2, pos. 1 and 2) of the VM-interior.
2. Remove the VM-interior (Fig. 5.2, pos. 3) straight (perpendicular) out of the VM frame.
3. Place the VM-interior (Fig. 5.3, pos. 1) straight (perpendicular) back into the VM frame (Fig. 5.3, pos. 2).
4. Check whether all 4 clips (Fig. 5.2, pos. 1 en 2) are clicked tight properly.
1
Fig. 5.2 - Removing VM interior from VM frame
Fig. 5.3 - Placing VM in VM frame
Placing the VM at an angle (Fig. 5.3, pos. 3) damages the VM. Always place the VM horizontally as shown in
Fig. 5.3, pos. 1 and pos. 2.
10001124369-0123-zw-zw-A4 ComfoVar Aero Installer_Service Zehnder-General_BOOK_2.indb 47 10001124369-0123-zw-zw-A4 ComfoVar Aero Installer_Service Zehnder-General_BOOK_2.indb 47
2
2
1
3
3
EN - 47
24-01-2023 11:11 24-01-2023 11:11