Changing The Control Devices - Reely SKY 20 69 33 Notice D'emploi

b) Changing the control devices
Your remote control is tuned ex works exactly to your double rotor electric powered helicopter. However, if during
trimming, you notice that your model helicopter, with individual steering functions, responds contrary to the pattern
illustrated in ill. 8 to 11, then you can switch over at the transmitter, for each individual steering function, the direction
of the response of the model (reverse function).
For that purpose, there is 12 DIP switches (1) on the rear side of the transmitter.
The switches 1 to 4 are assigned the following functions:
DIP switch Function
1 Nod function
2 Roll function
3 Pitch function
4 Tail function
The switches 5 to 12 have no function and were set to OFF by default.
To switch over a steering function, first disconnect the flight battery in the helicopter, then switch off the transmitter and
push the corresponding DIP switch in the other switch position. Now you can switch on the transmitter again, connect
the flight battery and check the correct function direction at the helicopter.
60
Factory setting
OFF
ON
OFF
OFF
Figure 21