Inspecting The Control Functions - Reely Hydro Force Notice D'emploi

c) Inspecting the Control Functions
After switching on the transmitter and connecting the drive battery to the model's speed controller, your
model is ready for operation. The motor should not start up or hum in this moment.
Attention!
The ship propeller is very sharp-edged and may cause injury and/or property damage when handling, repla-
cing and in operation.
Check the rudder linkage.
Operate the steering wheel for steering (figure 6, item 1). Steering to the left must cause the rudder (viewed from
behind in driving direction) to swivel to the left as well. If this is not the case, you need to select the steering servo
reverse function at the transmitter (see operating instructions of the remote control system).
If the steering wheel for the steering function at the transmitter as well as the trimming for it are in the neutral position,
the rudder must be placed centrally. Otherwise, the trimming at the transmitter must be adjusted accordingly (see
operating instructions of the remote control system).
Alternatively, or if transmitter trimming is no longer sufficient, you need to readjust the linkage with the control wheel in
the neutral position and neutral trimming by loosening the screws at the steering linkage (figure 3).
„Metal/metal" screw connections must be secured against unintended loosening either with so-called stop
nuts or with a drop of thread locker varnish.
Check the function „driving forwards". The throttle lever of the transmitter (figure 6, item 2) permits smooth adjustment
of the model's driving speed. The farther you push the lever to the handle, the faster must the ship's propeller turn and
the faster will the ship move forward.
If the motors only start up when the throttle lever is pushed forward, you need to activate the reverse function at the
transmitter for the control function „driving forward". For this, observe the operating instructions for the remote control
system.
Figure 6
43