c) Setting the gyrostatic effect
Besides the receiver and both electronic speed controllers for the electric driven motors, there is also a Piezo gyroscope
system integrated in the receiver/regulator module. This gyroscope system helps the tail of the helicopter to remain
stable when hovering and prevents it from swivelling to the side continuously due to air drafts or air turbulences.
The adjustment controller for the contact sensitivity of the
gyroscope (4) is located above the LED (5) of the receiver/
controller module (1).
You can make these adjustments with the enclosed small
screwdriver as well.
The further you turn the adjuster to the right, the stronger
the corrections on the tail rotor.
If the adjuster is turned too far towards the right, the
helicopter will tend to show oscillating movements around
the yaw axis (rotor shaft). In this case, turn the adjuster a
little bit towards the left again.
The control was perfectly set in the factory. For this reason, you should not change the setting if you are
satisfied with the control behaviour of the model.
64
Figure 24