Setup; Removing The Chassis; Installing The Antenna Cable For The Receiver; Inserting Batteries/Rechargeable Batteries Into The Remote Control - Reely Big1 Notice D'emploi

9. Setup

a) Removing the chassis
Remove the four safety clips on the upper side of the vehicle and lift the chassis off upwards.
b) Installing the antenna cable for the receiver
Route the aerial cables through the aerial tube included.
Plug the aerial tube into the corresponding bracket on
the vehicle (see arrow in the image on the right). Let any
excess aerial cable protrude slightly from the end of the
aerial tube.
Important!
Never cut the antenna cable! Never wind the
antenna cable! This significantly reduces the
transmission range.
c) Inserting batteries/rechargeable batteries into the remote control
Open the battery compartment on the remote control and insert new or fully charged batteries. Ensure that the
batteries are inserted in the correct polarity (observe the positive/+ and negative/- markings). Replace the battery
compartment cover.
Read the remote control instructions included with the product.
d) Configuring the remote control
Switch on the remote control and set the steering and throttle trim to the central position.
If the remote control has a dual rate feature, disable it or adjust it so that the steering angle is not limited.
Read the remote control instructions included with the product.
42