Publicité
Les langues disponibles
Les langues disponibles
ROUTINE MAINTENANCE
Before carrying out any routine maintenance operations, proceed as follows:
1.
take the machine to the maintenance area
WARNING: the place designated for this operation must comply with current regulations concerning safety at
work and current environmental protection regulations.
2.
put the machine in the safety position - refer to "SECURING THE MACHINE"
CAUTION: it is recommended to wear the appropriate PPE (Personal Protective Equipment), suitable for the
work to be carried out.
CLEANING THE RUBBER BLADES OF THE CENTRAL BRUSH
DUST GUARD
To clean the rubber blades in the central brush front dust guard kit, proceed as follows:
1.
Go to the left-hand side of the machine.
2.
Follow the procedure to remove the central brush - refer to "DISASSEMBLING THE CENTRAL BRUSH".
3.
Use a damp cloth to clean the bulkheads and rubber blades (1) in the machine frame (fig.1).
4.
Use a damp cloth to clean the bulkhead and rubber blade (2) of the right-hand side panel attached to the frame
(fig.2).
5.
1
1
6.
Use a damp cloth to clean the bulkhead and left-hand dust guard rubber blade (3) in the disassembled brush
inspection carter (fig.3).
N.B.: when cleaning the rubber blades, check their condition and state of wear. If they are unfit to be used,
contact your HILLYARD service centre of reference or the one closest to you.
7.
After completing the work, refit the brush following the instructions - refer to "ASSEMBLING THE CENTRAL
BRUSH".
2
2
39
3
3
Publicité
