Publicité
Les langues disponibles
Les langues disponibles
•
When the recharging cycle has been completed, disconnect the connector on the battery charger cable from
the connector on the battery power cable (fig.3).
•
Connect the connector on the machine power cable to the connector on the battery power cable (fig.2).
2
•
Close the bonnet by releasing the catch and rotating the bonnet to its working position.
WITH BUILT-IN BATTERY CHARGER (OPTIONAL)
The built-in battery charger ensures maximum performance because it has been purposely selected
for the sweeping machine on which it is mounted. It offers the convenience of being able to recharge
the machine wherever you are at the end of the shift, without having to return to a specific point on the
route.
WARNING: before running the battery charging cycle, check the battery charger is suitable for the batteries
you want to use. The battery charger in the machine is programmed by the factory with the following type of
charging curve: GelGeneric. To change the type of charging curve, contact your local HILLYARD service
centre or the one closest to you. Alternatively, you can send an email to missouriservice@hillyard.com, or visit the
website at
www.hillyard.com
N.B.: carefully read the battery charger use and maintenance manual (included in the bag that contains this
instruction booklet).
1
1
WARNING: before inserting the battery charger power cable in the socket (2), check there is no
condensation or any other type of liquid.
Carry out the following steps:
• Insert the battery charger power cable plug (6) in the mains socket (2)
(fig.2).
• The charger (1) is located above the battery (fig.1), so stand to the side of
the machine and remove the cap (5) covering the socket (4) on the charger
(fig.3).
• Connect the battery charger power cable connector (7) to the battery
charger socket (6) (fig.4).
26
3
Publicité
