Publicité
Les langues disponibles
Les langues disponibles
MOUNTING AND ADJUSTING THE HANDLEBARS
The handlebars in the control station can be adjusted to 3 different heights:
1
1. To adjust the handlebars, proceed as follows:
2. put the machine in the safety position - refer to "SECURING THE MACHINE"
3. open the bonnet and secure it with the catch
4. using the Allen spanner (provided with this manual), loosen the 4 handlebar support screws (2 on the right and
2 on the left) (fig.2)
5. position the handlebars at the required height, centring the screws with the relative holes in the frame
6. fasten the 4 screws with the Allen spanner
ATTENTION: for safety, check with a torque spanner that the tightening torque of all 4 hex head screws is
between 20 Nm and 25 Nm
DISASSEMBLING THE CENTRAL BRUSH
To mount the brush in the central tunnel, proceed as follows:
1.
take the machine to the maintenance area
2.
put the machine in the safety position - refer to "SECURING THE MACHINE"
CAUTION: it is recommended to wear the appropriate PPE (Personal Protective Equipment), suitable for the
work to be carried out.
3.
rotate the bonnet by lifting it from the control station side, and fasten the prop in the lower part of the retainer
plate (fig.1)
4.
unscrew the knobs of the central brush inspection carter and central brush lifting arm (fig.2)
5.
remove the central brush inspection carter (fig.3)
6.
remove the brush by pulling it out of the frame tunnel
1
2
2
28
3
Publicité
