Publicité
Les langues disponibles
Les langues disponibles
DISASSEMBLING AND ASSEMBLING THE SIDE BRUSH
To disassemble and assemble the side brush in the machine, contact a HILLYARD service centre technician.
WARNING: HILLYARD disclaims all responsibility for any injury to people or damage to property if the side
brush is replaced by an unauthorised technician.
WORK PREPARATION CHECKLIST
Check for any fluid leaks
Check the headlights (if installed)
Check the front wheel and rear wheels for damage
Check the battery charge level
Check the debris hopper (in the rear part of the machine)
is empty
Check all the dust guards of the central brush
compartment for signs of damage or wear
Check the central brush is not dirty, damaged or worn
Check the side brush is not dirty, damaged or worn
Check the condition of the vacuum filter on the debris
hopper
If you note any faults, contact your HILLYARD service centre
of reference or the one closest to you. Alternatively, you can
send an email to
missouriservice@hillyard.com
website
www.hillyard.com
If you note any faults, contact your HILLYARD service centre
of reference or the one closest to you. Alternatively, you can
send an email to
missouriservice@hillyard.com
website
www.hillyard.com
If you note any faults, contact your HILLYARD service centre
of reference or the one closest to you. Alternatively, you can
send an email to
missouriservice@hillyard.com
website
www.hillyard.com
Check the battery box charge level on the control display.
Recharge it if necessary. Refer to "RECHARGING THE
BATTERY"
If the debris hopper is full, empty it. Refer to "EMPTYING THE
DEBRIS HOPPER"
If you note any faults, contact your HILLYARD service centre
of reference or the one closest to you. Alternatively, you can
send an email to
missouriservice@hillyard.com
website
www.hillyard.com
If the brush in the central machine tunnel is dirty, clean it.
Refer to "CLEANING THE CENTRAL BRUSH"
If the brush in the central machine tunnel is worn or damaged,
replace it. Refer to "REPLACING THE CENTRAL BRUSH"
If the brush in the side brush head is dirty, clean it. Refer to
"CLEANING THE SIDE BRUSH"
If the brush in the side brush head is worn or damaged,
replace it. Refer to "REPLACING THE SIDE BRUSH"
If the collection filter is clogged or dirty, clean it. Refer to
"CLEANING THE PANEL FILTER"
30
or visit the
or visit the
or visit the
or visit the
Publicité
