Publicité
Les langues disponibles
Les langues disponibles
ASSEMBLING THE CENTRAL BRUSH
1. put the machine in the safety position - refer to "SECURING THE MACHINE"
2. unscrew the knobs of the central inspection carter and central brush arm
3. remove the central brush side inspection carter
4. insert the brush in the frame tunnel
N.B.: when the brush is mounted correctly, the cusps on the brush form an arrow ˄ when seen from above in
the forward movement direction (fig.3).
5.
rotate the brush until the fastening hooks (1) in the driving towing hook (2) (fig.1) correctly enter the slots (3) in
the brush (fig.2)
6.
insert the central brush inspection carter (fig.6)
1
2
1
ATTENTION: make sure the fastening hooks (5) in the idle towing hook (6) (fig.4) correctly enter the slots (7)
in the brush (fig.5).
5
6
4
7.
tighten the knobs (8) of the central brush inspection carter (fig.7)
3
2
7
5
8
9
7
29
4
3
6
Publicité
