Publicité
Les langues disponibles
Les langues disponibles
STARTING WORK
To start working, proceed as follows:
1.
carry out all the checks listed in the "WORK PREPARATION CHECKLIST" section
2.
go to the control station
3.
insert the key in the slot on the upper part of the bonnet
4.
turn the key clockwise to "I" and switch on the machine (fig.1)
5.
At the moment of ignition, the display will show a series of screens in sequence. Fig.2 shows the screen with
the machine programming characteristics.
N.B.: the upper left area of the screen shows the nominal battery voltage value (1), while the upper right area
shows the minimum permitted inhibit value (2).
1
6.
by manually pushing the machine via the handlebars, it will now work at full efficiency levels until the end of the
job or until the batteries run down
For the version with traction:
7. press the lever on the handlebars (fig.3); the machine will start to move and will work at full efficiency levels
until the end of the job or until the batteries run down
8. during work it may be necessary to temporarily stop the vacuum to prevent the collection of liquids (which
might wet the filter) or other unwanted elements. To do this, press and hold the vacuum lever (3) to temporarily
block the air flow
N.B.: pick up any large pieces of waste before performing the cleaning operations; pick up wire, tape, string,
large pieces of wood, or any other types of refuse that might wrap around the brushes or become entangled.
N.B.: drive the machine along the most linear path possible. Avoid hitting any obstacles and scratching the
sides of the machine. Overlap the working widths by several centimetres. To avoid damaging carpet floors,
do not turn the machine from one side to the other while it is stationary.
N.B.: remember that only the central brush has a dust vacuum system; the side brush can only channel the
dirt towards the central part of the machine.
1
24
2
31
2
21.4
3
3
Publicité
