Publicité
Les langues disponibles
Les langues disponibles
DANGER: move the packaged product with handling trolleys that comply with the load handling directives in
force in the country of use, and with the dimensions and mass of the packaged product.
HOW TO UNPACK THE MACHINE
The machine is shipped in specific packaging. To remove it, proceed as follows:
1.
Place the lower part of the outer packaging in contact with the floor.
N.B.: use the pictograms printed on the box as a reference.
2.
Remove the outer package.
WARNING: the machine is contained in specific packaging materials, whose elements (plastic bags, staples,
etc.) can pose potential hazards, and must not be left within reach of children, disabled persons, etc.
3.
Remove any boxes containing brushes or optionals.
CAUTION: it is recommended to wear the appropriate PPE (Personal Protective Equipment), suitable for the
work to be carried out.
4.
Place two descent ramps at the rear of the machine.
WARNING: the descent ramps are consigned in the machine packaging. If there are no ramps provided,
bear in mind the one used must have a suitable slope to avoid damaging the machine and a sufficient
load-bearing capacity to ensure it does not break when the machine moves across it. To obtain the net
weight of the machine and the safety percentage value required of the ramp, contact your HILLYARD service centre
of reference or the one closest to you. Alternatively, you can send an email to missouriservice@hillyard.com, or visit
the website www.hillyard.com.
5.
check the main switch is on "0". If it isn't, make a quarter turn anti-clockwise with the key (fig.3)
1
6. lift
bonnet and secure it with the relative side catch (see SECURING THE MACHINE)
7. turn the handlebars (fig.1) and tighten the 2 side screws (on both sides) in their respective holes (fig.2), using
the Allen wrench provided with the machine documentation
8.
tighten the other 2 screws (already inserted) as well, to fully secure the handlebars to the frame
9.
ATTENTION: for safety, use a torque spanner to check the tightening torque for all 4 hex head screws is
between 20 Nm and 25 Nm.
10. close the bonnet by releasing the catch and rotating the bonnet to the working position
2
20
the
Publicité
