Publicité
Les langues disponibles
Les langues disponibles
EMPTYING THE DEBRIS HOPPER
If you notice the machine can no longer collect dirt from the floor while cleaning, the debris hopper in the rear part
of the machine might be full.
To empty the debris hopper, proceed as follows:
1.
Take the machine to the designated waste disposal area.
N.B.: the place designated for this operation must comply with current regulations concerning safety at work
and current environmental protection regulations.
2.
Position the machine near the waste bin.
3.
Pull the filter shaker lever (1) on the control station a couple of times to clean the vacuum filter (fig.1).
N.B.: with electric filter shaker (optional): shut off the vacuum via the handle (2) (fig.1) in order to activate the
filter shaker and clean the filter.
4.
Put the machine in the safety position - refer to "SECURING THE MACHINE".
CAUTION: it is recommended to wear the appropriate PPE (Personal Protective Equipment), suitable for the
work to be carried out.
5.
free the debris hopper by rotating the retainers (3) in the direction indicated by the printed arrow (fig.2)
6.
gripping the handle (4) on the debris hopper (fig.3), remove it from the machine
2
1
1
7.
take the debris hopper to the designated unloading area and empty it
ATTENTION: when using the machine, pay attention to the debris hopper; it can contain up to 50 kg (110 lb).
Respect the general rules for manual movement of the loads. If heavy materials are incorrectly lifted and/or
moved, this may cause back injury or other types of personal injury.
8.
gripping the handle (4), insert the debris hopper in the machine (fig.3)
9.
to attach the hopper to the frame, rotate the retainers (3) in the direction indicated by the printed arrow
3
2
34
4
3
Publicité
