Usb Mode; Hardware Setup; Goggle Setup - Interacoustics EyeSeeCam Instructions D'utilisation

USB mode

The EyeSeeCam vHIT camera must only be connected to a USB 2.0 port. If the computer only has USB
3.0 ports the USB 3.0 controller must be disabled so that the ports will work in USB 2.0 mode.
To downgrade from USB 3.0 to USB 2.0 please go to the BIOS/Config menu and select "USB". Set the
USB 3.0 controller mode to "Disabled" and press F10 to Save and Exit the BIOS Config menu.
Figure 3.2.5-1 Bios Menu

Hardware setup

• Connect the USB cable to the computer
Connect the other end of the USB cable to the EyeSeeCam camera
•
Mount the camera on the goggle using the spherical ball-and-socket joint
•
• Mount the calibration laser on the bridge of the goggle
Connect the computer power supply to a wall outlet, then connect to computer
•

Goggle setup

T
he vHIT goggle generally has one camera (monocular) fixed at the top side(s) of the mask. The
camera is held in place mechanically with a spherical ball-and-socket joint. The vHIT goggle has two
spherical sockets: one for the left and one for the right eye. The spherical joint allows the camera to be
moved from the mask and plugged into the spherical socket of the other side. This allows for
examining either the left or the right eye, depending on which eye is better suited for examination. This
feature is particularly useful in patients with either a glass eye or with a ptosis.
EyeSeeCam vHIT - Instructions for Use - EN Page 7