Elica RATIO 804 PLUS BL Prescriptions De Montage Et Mode D'emploi page 18

Melt - thaw - keep warm - stir
-
Low power
Melt - thaw - keep warm - stir
OFF Support surface
4. MAINTENANCE
Please note! Before any cleaning or maintenance,
make sure the cooking zones are switched off and the
heat indicator has turned off.
HOB MAINTENANCE
● Cleaning the induction hob
The hob must be cleaned after each use.
Important:
• Do not use abrasive sponges, scouring pads. Their use,
5. ASSISTANCE
TROUBLESHOOTING TABLE
Informative code
For all other error sig-
nals
CUSTOMER SERVICE
Before contacting Customer Service
1. Check that the problem cannot be solved by consulting the points in "Troubleshooting".
2. Switch the device off and on again to see if the problem resolves itself.
If the fault persists after the above checks, contact the nearest Customer Service centre.
Description
The command zone switches off
due to an excessively high tem-
perature
Container unsuitable
Communication problems
between the user interface and
induction module
Call customer service and report the error code
melting butter, gently melting chocolate, defrosting small
products
keeping small portions of just-cooked food warm or main-
taining dishes at serving temperature and creaming risot-
tos
Hob in stand-by or off (possible presence of residual heat
from the end of cooking, signalled by H-L-O)
over time, may ruin the glass.
• Do not use irritant chemical detergents such as oven
sprays or stain removers.
• DO NOT USE STEAM JET CLEANERS!!!
After each use, leave the hob to cool and clean it to remove
deposits and stains caused by food residue. Sugar or food
with a high sugar content damage the hob and must be
removed immediately. Salt, sugar and sand may scratch
the glass surface. Use a soft cloth, paper towel or specific
products to clean the hob (follow the Manufacturer's
instructions).
Possible causes
The temperature inside the elec-
tronic parts is too high
Loss of magnetic properties
No power supply to the module;
the power cable has not been
connected correctly or it is faulty
18
Solution
Wait for the hob to cool be-
fore reusing it
Remove the pot
Disconnect the hob from the
electrical network and check
the connection