Publicité
Les langues disponibles
Les langues disponibles
Displayed value
To switch off the Timer:
• select Zone/Display (4)
• set the duration of the Timer to Zero
(5)
● Bridge Zones
Thanks to the Bridge function, the cooking zones can
operate in a combined way, creating a single zone with the
same power level. This function allows evenly distributed
cooking with large-sized pots and pans.
It is possible to use the front cooking zone in combination
with the corresponding rear one (to check which zones
feature this function, see the illustrated part of this manual).
To activate the Bridge Function:
• simultaneously select both cooking zones you wish
to use
• the Display (2) of the "rear" cooking zone will show the
symbol
• using the Selection bar (3), it will be possible to set the
operating Level (Power), which will be shown on the
Display (2) of the "front" zone
To disable the Bridge Function, simply repeat the activation
procedure
Note: the Cooking Zone Timer, activated during the Bridge
Function, causes the automatic shut-down of both cooking
zones, as in this case they are considered a single
combined area.
● Power Limitation
The Power Limitation function allows the product to be
used while limiting its maximum absorption, adjusting the
absorbed power in all active cooking zones, ensuring that
the total absorbed power of the hob does not exceed the
set maximum absorption level.
Note: the setting must be made with the hob switched off,
without pressing the
ON/OFF (1) button, when the hob
is connected to the mains, or reconnected to the mains,
within the next 2 minutes.
To set the Power Limitation:
• press
(which will flash, only for the first 2 minutes
after the product has been switched on)
• while keeping
held down, press, one at a time, all
the Selection/Display areas (2) of the cooking zones, in
this sequence, (FR-2 -> RR-2 -> RL-2 -> FL-2) as shown in
the figure:
Remaining time
1h and 35 min
1min. and 35 sec.
, using
At this point, the Display (RL-2) will show the symbols
and
alternately and the Display (FL-2) will show the
symbol
.
• select the Display (RL-2), the Selection bar (3) will light
up; select the penultimate vertical line on this bar. Now, the
Display (RL-2) will show the symbols
alternately.
At this point, it will be possible to change the absorption
value of the hob: Select the Display (FL-2) again and the
Selection bar (3) will light up again; select one of the three
available positions on this bar; according to this choice, the
Display (FL-2) will show a value between
The following table relates the displayed value to the
maximum absorption of the Hob:
Displayed value
To save the selection made, press the ON/OFF (1) key for
2 seconds; an extended audible signal will be emitted to
confirm the setting.
● Key Lock
The Key Lock allows you to lock the settings of the hob to
prevent accidental tampering with the same, while leaving
the set functions enabled.
Activation:
• press
(10) Repeat the operation to deactivate.
Note: if any other function is pressed while the Key Lock is
active, the symbol
is in use and must be deactivated if necessary in order to
use the hob.
● Automatic Heat UP
The Automatic Heat UP function allows the set power to be
reached more quickly; with this function it is possible to
cook food faster without the risk of burning it, insofar as the
temperature does not exceed the set level. This function is
16
and
Power (Kw)
7.2 Kw (default setting)
4.5 Kw
3.1 Kw
will flash to indicate that the function
and
.
Publicité
