Télécharger Imprimer la page

Barbecook SPRING 2002 Mode D'emploi page 11

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 31
5.
Set the control knob of one burner to HIGH.
Always light one main burner to start with. Never light all
main burners at the same time.
6.
lf the burner does not light within 5 seconds, set its control
knob to OFF, close the gas supply and wait 5 minutes. This
allows any accumulated gas to escape.
7.
Retry lighting the burner. lf it still does not light, refer to "14
Troubleshooting" to determine the cause of the problem.
8.
Once one burner is lit, light the other burners by setting their
control knobs to HIGH.
9.3 Switching the burners off
lf you no longer use the burners, you have to switch them off.
Proceed as follows:
1.
Close the gas supply.
2.
Set the control knobs of the burners to OFF.
By closing the gas supply first, you make sure there is
no gas left in the appliance.
9.4 Relighting the burners
lf a burner goes out while in use, proceed as follows:
1.
Open the lid and close the gas supply.
2.
Set all control knobs to OFF and wait 5 minutes. This allows
any accumulated gas to escape.
3.
Relight the burner(s).
9.5 Checking the flame
Each time you light a burner, you have to check its flames. A
perfect flame is almost comple ely blue, with some yellow at the
top. Sporadic yellow flames are normal and not harmful.
lf there is something wrong with the flames, do one of the
following to solve the problem:
If the flames are...
Low and entirely yellow
Higher than the bowl
Do the following...
1.
Immediately close the gas
supply and set all control
knobs to OFF.
2.
Refer to "Troubleshooting"
to determine the cause of
the problem. Most likely, the
venturis are blocked.
1.
Immediately close the gas
supply and set all control
knobs to OFF.
2.
Wait 5 minutes to allow any
accumulated gas to escape.
3.
Relight the burner(s).
4.
If the problem persists, refer to
"Troubleshooting" to determine
the cause of the problem.
LOW
10 USEFUL TIPS AND TRICKS
10.1 Preheating the appliance
By preheating your appliance, you make sure the grill is hot
enough by the time you put food on it. Proceed as follows:
1.
Light the burner(s) and set their control knob(s) to HIGH.
2.
Close the lid and leave the appliance for ten minutes.
3.
After ten minutes, open the lid and put your food on the grill.
4.
lf you need less heat now, set the control knob(s) to a lower
position.
10.2 Preventing food from sticking
To prevent your food from sticking to the grill:
Oil the food lightly with a brush before you put it on the grill.
You can also oil the grill itself.
Preheat the appliance. The warmer the grill when you put food
on it, the less the food will stick.
Do not turn the food too quickly. Let it catch some heat first.
10.3 Direct and indirect grilling
Depending on the type of food you are preparing and on how
you want to prepare it, you can grill directly or indirectly:
Method
Description
Put your food directly
Direct
above a lit burner, set
that burner to a high
position and keep the
lid open.
Indirect
Put your food next to
a lit burner, set that
burner to a medium/
low position and close
the lid.
When grilling under a closed lid, always keep an eye on
the lid thermometer to make sure the appliance does not
get too hot. See "10.5 Watching the temperature".
HIGH
Use
To sear meat and
vegetables
To further cook
seared meat
11

Publicité

loading

Ce manuel est également adapté pour:

Bc-gas-2009