Publicité
Les langues disponibles
Les langues disponibles
Obligations of
The operating company must only allow persons to work with the device if they:
the operating
-
company
-
-
The safety-conscious work of the personnel must be checked regularly.
Safety Inspec-
The manufacturer recommends that a safety inspection of the device be per-
tion
formed at least every 12 months.
A safety inspection by a certified electrician is recommended
-
-
-
-
For the safety inspection, follow the appropriate national and international
standards and guidelines.
You can obtain more information about the safety inspection from your service
center. The service center will provide the necessary documents upon request.
Markings on the
Devices bearing the CSA label satisfy the essential requirements of applicable
device
directives.
Disposal
Waste electrical and electronic equipment must be collected separately and re-
cycled in an environmentally sound manner in accordance with the European Dir-
ective and national law. Used equipment must be returned to the distributor or
through a local authorized collection and disposal system. Proper disposal of the
used device promotes sustainable recycling of material resources. Failure to ob-
serve this may lead to potential health/environmental impacts.
Packaging materials
Separate collection. Check your municipality's regulations. Reduce the volume of
the box.
Copyright
Copyright of these Operating Instructions remains with the manufacturer.
Text and illustrations were accurate at the time of printing. Fronius reserves the
right to make changes. The contents of the Operating Instructions shall not
provide the basis for any claims whatsoever on the part of the purchaser. If you
have any suggestions for improvement, or can point out any mistakes that you
have found in the Operating Instructions, we will be most grateful for your com-
ments.
12
are familiar with the basic occupational safety and accident prevention regu-
lations and are trained in handling the device,
have read and understood these Operating Instructions, especially the
"Safety rules" section, and have confirmed this with their signature,
are trained according to the requirements for the work results.
after changes,
after alterations,
after repair, service and maintenance,
at least every 12 months.
Publicité
