Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
CAUTION
Do not allow contact between the common and the fixture's chassis ground. Grounding the com-
mon can cause a ground loop, and your fixture may perform erratically. Test cables with an ohm
meter to check correct polarity and to make sure the pins are not grounded or shorted to the shield
or each other.
FEATURES
• 15 or 27 DMX channels
• 19x 20W 4-in-1 OSRAM LEDs
• 10°-60° Zoom
• Individual control of 3 LED zones
• Virtual color wheel with a selection of 33 LEE filters
• Color Macros
• Rainbow effects
• CTO Color temperature correction
• Various strobe effects
• 4 dimmer modes
• Blue LCD
• Powercon in/output allowing to link up to 10 moving heads
• 3- & 5-pin DMX connectors
• Supplied with 2 omega clamps
• Perfect for stage, theater, TV studio, rental and discotheques.
Settings
CONTROL PANEL
1. Function Display:
Shows the various menus and the selected functions
2. LED:
POWER
DMX
3. BUTTONS
Button Function
MENU
To select the programming functions
UP
To go backward in the selected functions
DOWN
To go forward in the selected functions
ENTER
To confirm the selected functions
To access the main menu press the MENU button. Press the UP or DOWN buttons until you reach
function you wish to change. When you reach the function you wish to change, press the ENTER
button. When a function is selected, use the UP or DOWN buttons to change the function settings.
Once your changes are made, press the ENTER button. To go back to the functions without any
change press the MENU button again. Press and hold the MENU button for about one second or
wait for one minute to exit the menu mode
4. DMX IN:
DMX512 link, use 3/5-pin XLR cable to link the unit and the DMX controller
EN
4
ON
ON
Power On
DMX input present
© Copyright LOTRONIC 2020
Publicité
Table des Matières
