Factory Setting; Fixture Cleaning - afx light LEDWASH-1920Z Manuel D'utilisation

FACTORY SETTING

To select Factory Setting, press the ENTER button to show the FACTORY SETTING on the display.
Press the ENTER button to confirm, use the UP/DOWN button to select No or Yes (the fixture will
reset to factory settings and exit menu mode).
HOME POSITION ADJUSTMENT
OFFSET MENU
In the main menu, hold down the ENTER button for at least 3 seconds to go into OFFSET mode, use
the DOWN/UP buttons to select Pan Offset, Tilt Offset or Zoom Offset, and press the ENTER button
to confirm. Use the DOWN/UP buttons to adjust the home position of the Pan, Tilt or Zoom. Once
the position has been selected, press the ENTER button to confirm. To go back to the functions wit-
hout any change, press the MENU button again. Press and hold the MENU button about one second
or wait for about one minute to exit the menu mode.

FIXTURE CLEANING

Due to fog residue, smoke, and dust cleaning the internal and external optical lenses and mirror
should be carried out periodically to optimize light output. Cleaning frequency depends on the en-
vironment in which the fixture operates (I.e. smoke, fog residue, dust, dew). In heavy club use we
recommend cleaning on a monthly basis. Periodic cleaning will ensure longevity and brightness.
• Clean with soft cloth using normal glass cleaning fluid.
• Always dry the parts carefully.
• Clean the external optics at least every 30 days.
TROUBLE-SHOOTING
Following are a few common problems that may occur during operation. Here are some sugges-
tions for easy troubleshooting:
A. The unit does not work, no light and the fan does not work
1. Check the connection of power and main fuse.
2. Measure the mains voltage on the main connector.
3. Check the power on LED.
B. Not responding to DMX controller
1. DMX LED should be on. If not, check DMX connectors and cables to see if link properly.
2. If the DMX LED is on and no response to the channel, check the address settings and DMX po-
larity.
3. If you have intermittent DMX signal problems, check the pins on connectors or on PCB of the
unit or the previous one.
4. Try to use another DMX controller.
5. Check if the DMX cables run near or run alongside to high voltage cables that may cause da-
mage or interference to DMX interface circuit.
C. One of the channels is not working well
1. The stepper motor might be damaged or the cable connected to the PCB is broken.
2. The motor's drive IC on the PCB might be out of condition.
PAN
TILT
ZOOM
www.afx-light.com
-128~127
-128~127
0~255
9 EN