Control Panel - afx light PARCOB150WH-MKIII Manuel D'utilisation

Addressing
The control board allows you to assign the DMX starting address,
Note; it's necessary to insert the XLR termination plug (with 120ohm) in the last device in the link in order to ensure proper
transmission on the DMX data link.

CONTROL PANEL

The control panel offers several features: you can simple set the starting address, run the pre-programmed program or make a
reset.
• The main menu is accessed by pressing the Mode/Esc-button.
• Browse through the submenu by pressing Up or Down.
• Press the Enter-button in order to select the desired menu. You can change the selection by pressing Up or Down. Confirm
every selection by pressing the Enter button.
• You can leave every mode by pressing the Mode/Esc-button.
The functions provided are described in the following setting.
M EN U M A P
The device has two operation modes: It can be operated in manual or DMX mode.
When in Master/Slave Mode, only one unit in a series chain can be set as the master.
STAT ST.00
A.000 Adjust cold white from 0~255
B.000 Adjust warm white from 0~255
DMX and SLAV mode for selection
RUN
DMX Adjust DMX value from 001 to 512
CURR show current fixture temperature
TEMP
FAN
Master/slave mode (auto-running, sound control)
This mode will allow you to link up 32 units together without a controller. Use standard DMX cables to daisy chain your units
together via the DMX connector on the rear of the unit.
DMX-protocol
Channel
1
2
3
© Copyright LOTRONIC 2019
Adjust strobe effect from 0~20
Current setting temperature 30-55, default setting 40
Value Function
Dimmer
0-255 0-100% dimmer
Cold white
0-255 0-100%
Warm white
0-255 0-100%
PARCOB150WH-MKIII Page 4