Control Panel - afx light HOTBEAM-3R Manuel D'utilisation

Connectors on the rear panel
1) DMX in 3 pins
2) Power switch
3) Power in
4) DMX out 3 pins
5) Fuse F6AL250V
If the device stays off when you switch it on, please
check the fuse.
If the fuse is broken, change it by the same value and same size fuse
LAMP REPLACEMENT
IMPORTANT: Disconnect the unit from the mains prior to opening the lamp compartment.
Don't touch the lamp with bare hands. If the lamp is hot, please wait at least 20 minutes to let it cool down. Fasten the head
with the Tilt lock in 60° position.
Remove the 2 screws on the rear panel via a cross-headed screwdriver and remove the cover.
Keep the lamp holder in place with one hand and pull out the wire and the lamp with the other hand.
Once you have removed the lamp, clean
the inside part of the lens to get a
brighter light output.
Push in the new lamp, place the wire
inside the compartment and close the
compartment with the 2 screws.
OPERATION

CONTROL PANEL

The LCD display shows you all information about moving head control
The wheel is used to select all menus and validate your settings.
Control wheel: turn right, left and press
CW rotation: increases the value
CCW rotation: decreases the value
Press to select a menu item or confirm your setting
Main Menu Sub-menu 1
DMX
Address
Disp Flip
Disp Dim
Display
Bcklight
Menuback
© Copyright LOTRONIC 2017
Submenu 2 Function SET
001-512
OFF
ON
000-255
1 min
2 min
3 min
ON
1 min
2 min
Function description
Setting of DMX address
Normal display
Reversed display by 180°
Brightness
Backlight closes after a delay of 60 sec.
Backlight closes after a delay of 120 sec.
Backlight closes after a delay of 180 sec.
Backlight stays always on
Back to main menu after a delay of 60 sec.
Back to main menu after a delay of 120 sec.
HOTBEAM-3R Page 5