Control Panel - afx light Shooter-2 Manuel D'utilisation

and connect to the DMX input of second slave light from the DMX output of the first master light, analogously, till
connected all the slave lights, and insert the last connector to the output of the final light. (Notice: the diameter of
core of every cable should be 0.5mm at least, double core shelter cable should be used).The signal connecting must
use the attached 3 pins XLR cable. Notice, all the internal lead wire of the 3 pins XLR cable should not touch to each
other or connect to the connector.
DMX signal terminator is recommended on the last unit of the chain. DMX terminator is a XLR connector with a
120Ω resistor between the pin 2 and pin 3 of the XLR connector
DESCRIPTION
1)

CONTROL PANEL

Use these 4 buttons and this display to setup the shooter-2r
2) DMX INPUT
Connect the dmx controler to this input to control SHOOTER-2R in DMX mode
3) DMX OUTPUT
Connect another SHOOTER-2R or an other DMX device to this ouput
4) FUSE
5) POWER SUPPLY INPUT
6) POWER SUPPLY OUTPUT
7) LAMP PLACE
When the lamp is out of order and must be changed, remove this plate to change the lamp
© Copyright LOTRONIC 2015 SHOOTER-2R Page 5