White Balance; Dimmer Curve - afx light LEDWASH-1920Z Manuel D'utilisation

Use the UP/DOWN button to select No (Pan or tilt's position will not feedback while out of step) or
Yes (Feedback while pan/tilt out of step), press the ENTER button to setup. Press the
MENU button back to the last menu or let the unit idle one minute to exit menu mode.
BL.O. P/T MOVING
To select BL.O. P/T Moving, press the ENTER button to show BLACKOUT WHILE PAN/TILT MOVING
on the display. Uuse the UP/DOWN buttons to select No (normal while pan/tilt moving) or
Yes (blackout while pan/tilt moving). Press the ENTER button to confirm. Press the MENU button to
go back to the last menu or let the unit idle one minute to exit menu mode.

WHITE BALANCE

To select White Balance, press the ENTER button to show WHITE BALANCE on the display. Use
the UP/DOWN buttons to select Red, Green or Blue. Once selected, press the ENTER button to
confirm. Use the UP/DOWN buttons to adjust the value from 125 to 255. Press the ENTER button
to confirm. Press the MENU button to go back to the last menu or let the unit idle one minute to
exit menu mode.

DIMMER CURVE

To select Dimmer Curve, press the ENTER button to show DIMMER CURVE on the display. Use the
UP/DOWN buttons to select Linear, Square Law, Inverse Squ. or S-curve. Once selected, press the
ENTER button to store. Press the MENU button to go back to the last menu or let the unit idle one
minute to exit menu mode.
Linear: The increase in light intensity appears to be linear as DMX value is increasing.
Square Law: Light intensity control is finer at lower levels and coarser at higher levels.
Inverse Square Law: Light intensity control is coarser at lower levels and finer at higher levels.
S-curve: Light intensity control is finer at low levels and high levels and coarser at medium levels.
DISPLAY SETTING
Enter MENU mode, select Display , press the ENTER button to confirm, use the UP/DOWN button to
select Display Inverse, Backlight adjust, Temperature unit or Backlight off.
DISPLAY INVERSE
To select Display Inverse, press the ENTER button to show DISPLAY INVERSE on the display. Use
the UP/DOWN button to select No (normal) or Yes (display inverse). Once selected, press the ENTER
button to store. Press the MENU button back to the last menu or let the unit idle one minute to exit
menu mode.
BACKLIGHT AUTO OFF
To select Backlight Auto Off, press the ENTER button to show BACKLIGHT AUTO OFF on the display.
Use the UP/DOWN button to select No (display always on) or Yes (display goes off one minute after
exiting menu mode). Once selected, press the ENTER button to confirm and store. Press the MENU
button back to the last menu or let the unit idle one minute to exit menu mode.
BACKLIGHT ADJUST
To select Backlight Intensity, press the ENTER button to show BACKLIGHT ADJUST on the display.
www.afx-light.com
7 EN