Table des Matières
Publicité
Features
•
7/10/12 DMX channels
•
Sound active, DMX, auto, master-slave mode
•
Color wheel: 8 colors + white, spilt colors, rainbow effect
Gobo wheel: 9 static gobos + white, rainbow effect, gobo shake
•
•
Manual focus
•
Variable electronic dimmer (0-100%)
•
Shutter: 0-20Hz
Strobe
•
Specifications
Power supply ..................................................................................... 100-240Vac 50/60Hz
Consumption ............................................................................................................. 100W
Fuse ................................................................................................... 5 x20mm T3A / 250V
Light source ............................................................................ White ultra bright 60W LED
Pan .......................................................... 540°/360°/180°, 8/16 bit movement resolution
Tilt ............................................................. 230°/180°/90°, 8/16 bit movement resolution
Beam angle .................................................................................................................... 15°
Dimensions .......................................................................................... 370 x 250 x 220mm
Weight ........................................................................................................................ 3.8kg
Installation
The unit should be mounted via its screw holes on the bracket. Always ensure that the unit is firmly fixed to avoid
vibration and slipping while operating. Always ensure that the structure to which you are attaching the unit is secure
and able to support a weight of 10 times of the unit's weight. Also always use a safety cable that can hold 12 times
the weight of the unit when installing the fixture.
The equipment must be fixed by professionals at a place where is out of the reach of people and where nobody can
pass by or under it.
Fuse Replacement
Disconnect the power cord before replacing a fuse and always replace with the same type fuse.
With a screwdriver wedge the fuse holder out of its housing.
Remove the damaged fuse from its holder and replace with exactly the same type of fuse.
Insert the fuse holder back in its place and reconnect power.
Warning: If after replacing the fuse you continue to blow fuses, STOP using the unit. Contact customer support for
further instructions. Continuing to use the unit may cause serious damage.
CONTROL PANEL
To access the main menu press the MENU button. Press the UP or DOWN buttons
until you reach function you wish to change. When you reach the function you
wish to change, press the ENTER button. When a function is selected, use the UP
or DOWN buttons to change the function settings. Once your changes are made,
press the ENTER button.
©Copyright LOTRONIC 2017
SPOTY60LED
Page 3
Publicité
Table des Matières
