Control Panel; Function Menu; Function Mode - afx light 9BEAM-FX Manuel D'utilisation

consisting of a (male) 3 pin connecter. Then, proceed to connect from the output as stated above
to the input of the following fixture and so on.
Often, the set up for Master-Slave and Stand-alone operation requires that the first fixture in the
chain be initialized for this purpose via either settings in the control panel or DIP-switches. Se-
condarily, the fixtures that follow may also require a slave setting. Please consult the '' Operating
Instructions» section in this manual for complete instructions for this type of setup and configu-
ration.

CONTROL PANEL

To access the main menu press the MENU button. Press the UP or DOWN
buttons until you reach function you wish to change. When you reach the
function you wish to change, press the ENTER button. When a function
is selected, use the UP or DOWN buttons to change the function settings.
Once your changes are made, press the ENTER button.

FUNCTION MENU

DMX Address
Channel Mode
Show Mode
Slave Mode
Black Out
Sound State
Sound Sense
Pan Inverse
Tilt1Inverse
Tilt2Inverse
Tilt3Inverse
Back Light
Auto Test
Fixture Time
Firmware Version
Defaults
System Reset

FUNCTION MODE

DMX address setting
With this function, you can adjust the desired DMX-address via the Control Board.
1. Press the either the MENU, UP or DOWN buttons until "ADDR" is displayed, press ENTER.
2. The current address will now be displayed and flashing. Press the UP or DOWN buttons to find
your desired address. Press ENTER to set your desired DMX address.
Channel Mode: The unit has 13 or 44 channels that can receive the International DMX signal.
Show Mode: The user can select between [Sound] and [Auto] mode
Slave Mode: In [Slave] mode, you can chose [Master] mode and [Slave] mode.
Black Out: Select [YES] or [NO] to black out or not
Sound State: Sound control [ON] or [OFF]
A001---A512
13 ch, 44ch
Sound, Auto
Master, Slave
YES, NO
ON, OFF
0 –100 off – the most sensitive
YES, NO
YES, NO
YES, NO
YES, NO
On, Off
Automatic test
0----9999
V104
YES,NO
YES,NO
www.afx-light.com
8.8.8.8.
MENU UP DOWN ENTER
5 EN