Installing The Battery - TOHATSU MFS 15C Manuel De L'utilisateur

1. Cable harness B
2. Shift cable
3. Throttle cable
1. Drag link
ENOW00100-0
CAUTION
Be careful not to loop the remote control
cables to a diameter of 406 mm (16 inches)
or less.
ENON00301-0
Note
Confirm whether the shift of engine is in
gear when shifting the control lever of the
Remote Control to its first position in For-
ward or Reverse (about 32°) and whether
the throttle valve is fully open when shifting
the lever further.
Confirm whether the throttle valve is fully
closed when the control lever is shifted to
the Neutral position.
3. Connecting the Cord assembly (Wiring
1
2
3
ENOF00306-0
1. Cable Harness A (Outboard motor side)
2. Cable Harness B (From remote control)
ENOW00011-0
Do not disconnect the cord assembly when
the outboard motor is in operation or you
1
will lose control of the outboard motor.
ENOF00307-0
ENOM00029-0
1. Place the battery box in a convenient
ENOW00012-0
Battery electrolyte contains sulfuric acid
and thus is hazardous, causing a burn if it
comes in contact with your skin, or poison-
ous if swallowed.
Keep battery and electrolyte away from
reach of children.
Harness).
Connect cable harness B to cable har-
ness A.
Location of the connectors is near the
recoil starter of starboard side in the
cowl.
1
WARNING

3. Installing the battery

position away from possible water
spray. Securely fasten both the box
and the battery so they do not shake
loose.
WARNING
21
INSTALLATION
2
ENOF00021-0