Installation; Mounting The Outboard Motor On Boat - TOHATSU EverRun MX 25H Manuel De L'utilisateur

12

INSTALLATION

1. Mounting the outboard motor on
boat
Most boats are rated and certified in terms
of their maximum allowable horsepower,
as shown on the boat's certification plate.
Do not equip your boat with an outboard
3
motor that exceeds this limit. If in doubt,
contact your dealer.
Do not operate the outboard motor until it
has been securely mounted on the boat in
accordance with the instructions below.
Installation
 Single-engine Installation
Set engine at center of boat.
Center of Boat
A
 Twin-engine Installation
When installing two outboard engines, be
sure to keep an interval of approximately
580 mm (22.8 in) between the two.
WARNING
Boat Transom
A
Approx.580 mm (22.8 in)
Transom matching
1
Be sure that the anti ventilation plate of
the outboard motor is 30-50mm (1.2-2
in) below the bottom of hull.
If the above condition cannot be met
due to the shape of the bottom of your
boat, please consult your authorized
dealer.
2
To attach the outboard motor to the
boat, tighten the clamp screws by turn-
ing their handles.
Also, use the bolts to secure the out-
board motor brackets on transom
board.
Secure the outboard motor with a rope
to prevent loss overboard.
Note
A rope is not included in the standard
accessories.
Bottom of hull
30-50 mm
(1.2-2 in)
Anti Ventilation Plate