TRAILERING
ENOW00067-0
WARNING
Do not go under outboard motor tilted up
even if it is supported by support bar, or
accidental fall of outboard motor could
lead to severe personal injury.
ENOW00068-0
WARNING
Close air vent screw of fuel tank and fuel
cock before carrying or storing outboard
motor and fuel tank, or fuel may leak,
potentially catching fire.
ENOW00069-0
WARNING
When taking outboard motor from package
or removing outboard motor from the boat,
never release the lock lever. If the lock
lever is released, it will very easy for the
clamp bracket to spring up to the tilting
direction because it is not fixed.
ENOW00070-0
WARNING
Never attempt to disassemble shock
absorber of gas assist tilt system. It is dan-
gerous because high pressure gas is
included in the shock absorber.
*Care must be taken so as not to release
lock lever by accident.
*For more safety, tie the clamp bracket to
the outboard motor with a rope.
*Pay attention to the tilting direction so as
not to be injured by the springing stern
bracket.
ENOW00071-0
CAUTION
The tilt support device supplied on your
outboard motor is not intended for towing.
It is intended to support the outboard
motor while the boat is docked, beached,
etc.
ENOW00072-0
CAUTION
When trailering the outboard motor should
be in a vertical (normal running) position,
fully down. Trailering in the tilted position
may cause damage to the outboard motor,
boat, etc.
If trailering with outboard motor fully down
is not available (the gear case skeg is too
close to the road in a vertical position), fix
the outboard motor securely using a device
(like a transom saver bar) in the tilted posi-
tion.
A. Ground clearance should be provided sufficiently.
ENOW00073-0
WARNING
Please disconnect fuel connector except
when operating engine.
A
ENOF00074-0
49