Propeller Selection; Installing The Battery - TOHATSU EverRun MX 40D2 Manuel De L'utilisateur

14
INSTALLATION
Clamp Bracket
Dimensional Drawing
 Manual tilting type
3
Washer
(small diameter)
Bolt
(12mm x length 105mm)
117(4.61")
ø13
102(4.02")
ø13
Mounting bolts should be installed with the
bolt head at inside surface of the transom.
Mounting bolts installed with the threaded
end at the inside surface of the transom
can cause personal injury.
Washer
(large diameter)
Nut
234(9.21")
Top of transom
117(4.61")
39(1.54")
25(0.98")
64(2.52")
25(0.98")
89(3.50")
204(8.03")
102(4.02")
222(8.74")
26(1.02")
248(9.76")
CAUTION

2. Propeller Selection

Propeller must be selected that will allow
the engine to reach recommended rpm
when cruising at wide-open throttle.
Wide-open throttle rpm range
5000–5800 rpm
Genuine propellers are listed on PROPEL-
LER TABLE of this manual.

3. Installing the battery

1
Place the battery box in a convenient
position away from possible water
spray. Securely fasten both the box and
the battery so they do not shake loose.
WARNING
Battery electrolyte contains sulfuric acid
and thus is hazardous, causing a burn if it
comes in contact with your skin, or poison-
ous if swallowed.
Keep battery and electrolyte away from
reach of children.
When handling the battery, be sure to:
 Read all warnings shown on the battery
case
 Prevent electrolyte from coming in con-
tact with any part of your body. Contact
can cause serious burn or, if it comes in
contact with your eye, loss of sight. Use
safety glasses and rubber gloves.
In case battery electrolyte comes in con-
tact with:
 Skin, flush thoroughly with water.
 Eye, flush thoroughly with water, and
then seek immediate medical treatment.
In case battery electrolyte is swallowed:
 Seek immediate medical treatment.