AOIP CALYS 1500 Mode D'emploi page 173

C.8.3 Preferences
To display the Preferences dialogue box, use the Configuration
The adjustable parameters are:
Filtering: Used to average measurements before display. When filtering is switched off, the integration time for
measurements is 0.5 seconds.
Resolution: Used to adjust the resolution of the measurements when displayed. There are three possible choices:
HIGH: displays measurements with the highest possible resolution.
AVERAGE: displays one digit fewer compared with the HIGH resolution mode.
LOW: displays two digits fewer compared with the HIGH resolution mode.
Temperature units: used to select the temperature units, either ° C, ° F or K, for measurements and simulation.
Lighting: used to set the on time of the lighting before it is switched off to save the batteries.
Beep keys: used to switch on or off the transmission of an audible signal when pressing keys on the keyboard.
Language: used to select the language of the display in menus, dialogue boxes and on-line help.
Setting parameters
Setup Preferences... menus.
NTA47271-300A2
C
173/184