AOIP CALYS 1500 Mode D'emploi page 148

CALYS 1500
C. ADVANCED OPERATION
C.1 Simulation Modes
Several transmission modes are available in the CALYS 1500 to facilitate rapid checking and calibration of instruments
and transmitters.
To change the transmission mode, open the transmission window using the OUT function key (F2).
When the transmission window is open, the CALYS 1500 is set by default to the Manual edit mode.
To access the other modes, select the Mode menu using function key F4. Select a transmission mode using the Up/Down
keys of the navigator and confirm with ENTER.
To exit a transmission mode and return to the default mode, press the ESC key.
C.1.1 Manual Edit Mode
In this mode, the value to be transmitted may be entered directly using the alphanumeric keys.
The value entered appears at the bottom of the transmission window during entry.
To cancel the entry, press the ESC key. To transmit the value entered, confirm with the ENTER key.
148/184 NTA47271-300A2
GENERAL
Setting entered
manually