AOIP CALYS 1500 Mode D'emploi page 108

CALYS 1500
A.4 Safety
A.4.1 Compliance with safety standards
The unit complies with applicable standards:
- Safety directive 2006/95/CE with standard EN611010-1
- Directive CEM 2004/108/CE with standard EN61326-1
This user manual contains information and warnings which must be observed in order to protect the user against the
hazards of electric current, to ensure the safe operation of the device and to protect it against any mishandling which could
damage or compromise the safety of use of the device.
A.4.2 Environnemental conditions
As per publication EN 60359:
Range of application of standards: from 0 to 2,000 m max.
Reference temperature range: 23° C ±5° C, relative hu midity: 45% to 75%.
Nominal operating range: -10° C to +50° C (Except duri ng battery charging), relative humidity: 20% to 80% non-
condensing.
Operating range limit: -15° C to +55° C (Except during battery charging), relative humidity: 10% to 80% (70% at 55° C) max.
Storage and transport temperature range limit: -30° C to +60° C max (without the batteries).
When operating, the maximum operating temperature of the LIPO battery is below 40° C.
A.4.3 Used devices
Used electrical devices can pollute the environment. We recommend you refrain from disposing of this device in an
ordinary waste bin, but rather that you use the recycling circuits available locally. If not, you can return the device to us,
and we will take care of its disposal free of charge.
A.4.3.1 Waste generated by the device
List of waste classified according to the decree published:
16.02.14: Waste originating from electronic equipment:
Printed circuit boards making up the device
16.06.02: Batteries and storage battery (dangerous)
LiPo battery (Lithium Polymer 7.4 V)
Lithium 3V battery (type CR1225)
15.01.02: Packaging
Case in Aluminium and galvanized stee
A.4.3.2 Device destruction procedure
Opening the device: unscrew the 2 screws placed on top of each side of the unit to remove the top plate.
Separate the 2 shells. Separate the PCB from the upper shell.
Remove the battery pack and the Lithium battery.
A.4.4 Instructions
The unit is designed to be used in complete safety if the instructions given in the accompanying documents are followed.
Any use apart from those defined, may prejudice the safety of the operator and is therefore dangerous and forbidden.
108/184 NTA47271-300A2
GENERAL