Installing Effect Expansion Boards; Cautions When Installing An Effect Expansion Board - Roland VS-1880 Mode D'emploi

Préparatifs

Installing Effect Expansion Boards

Pour la version française de cette section, reportez-vous aux pages 11 à 13.
A VS8F-2 effect expansion board is optionally available. When one or two
VS8F-2 boards are installed, you will be able to use up to two stereo effects
for each board without connecting any additional equipment to the VS-
1880. Up to two of these effect expansion boards may be installed in the VS-
1880. In order to take full advantage of the VS-1880's functionality, we
recommend that you install at least one effect expansion board.
Cautions When Installing an Effect Expansion
Board
● To avoid the risk of damage to internal components that can be caused
by static electricity, please carefully observe the following whenever you
handle the board.
• Before you touch the board, always first grasp a metal object (such as a
water pipe), so you are sure that any static electricity you might have
been carrying has been discharged.
• When handling the board, grasp it only by its edges. Avoid touching
any of the electronic components or connectors.
• Save the bag in which the board was originally shipped, and put the
board back into it whenever you need to store or transport it.
● Use a Phillips screwdriver that is suitable for the size of the screw (a
number 2 screwdriver). If an unsuitable screwdriver is used, the head of
the screw may be stripped.
● PTo remove a screw, rotate the screwdriver
counter-clockwise. To tighten a screw, rotate
the screwdriver clockwise.
● When installing effect expansion boards,
remove only the specified screws.
● Be careful that the screws you remove do not drop into the interior of the
VS-1880.
● Do not leave the bottom cover in a detached state. Be sure to reattach it
after the effect expansion boards have been installed.
● Do not touch any of the printed circuit pathways or connection
terminals.
● Be careful not to cut your hand on the edge of the installation bay.
● Never use excessive force when installing a circuit board. If it doesn't fit
properly on the first attempt, remove the board and try again.
● When circuit board installation is complete, double-check your work.
8
Dévissez Vissez