Becker R8/17PFR+ Notice D'utilisation page 24

9a)
Clack
9b)
2x
9c)
2x
Clack - Clack
10)
Clack
Clack
Clack - Clack
Action
9) Ventilation position
Note
This function is used to move your roller shutters from the lower end limit
upwards in order to open the ventilation slats. The ventilation position can
only be set after the two end limits have been set.
9a) Setting the ventilation position
Adjust the shutter into the desired ventila-
tion position.
First press and hold the STOP button. Within
3 seconds also press the UP button and keep
both buttons pressed.
9b) Adjusting the shutters into the ventilation position
Note
The shutters move into the ventilation position from the lower end limit.
Press the UP button twice within one sec-
ond.
9c) Deleting the ventilation position
Adjust the shutter into the ventilation posi-
tion.
First press and hold the STOP button. Within
3 seconds also press the UP button and keep
both buttons pressed.
10) Learning additional transmitters
Note
In addition to the master transmitter, up to 15 transmitters can be learnt
into the tubular drive system.
Press the learn button of the master trans-
mitter programmed in 3) for 3 seconds.
Now press the learn button of a new trans-
mitter which is unknown to the tubular
drive for 3 seconds. In doing so, the tubular
drive goes into the programme mode for a
new transmitter for 3 minutes.
Now press the learn button of the transmit-
ter to be programmed for a further 3 sec-
onds.
24
Operating Instructions
Response
The tubular drive makes a "clack" sound to
confirm.
The ventilation position has been stored.
The shutter curtain moves into the ventila-
tion position.
The tubular drive makes a "clack-clack"
sound to confirm.
The ventilation position has been deleted.
The tubular drive makes a "clack" sound to
confirm.
The tubular drive makes a "clack" sound to
confirm.
The tubular drive makes a "clack-clack"
sound to confirm.
The new transmitter has been programmed.