Becker R8/17PFR+ Notice D'utilisation page 25

Operating Instructions
11a)
Clack
Clack
Clack - Clack
11b)
Clack
Clack
Clack - Clack
12a)
Mains connection
blue
N
black
L1
green/yellow
PE
Clack - Clack
11) Deleting transmitters
11a) Deleting transmitters individually
Note
The master transmitter which was programmed in point 3) cannot be
deleted. It can only be overwritten (see Point 12).
Press the learn button on the master trans-
mitter for 3 seconds.
Now press the learn button of the transmit-
ter to be deleted for 3 seconds.
Then press the learn button of the transmit-
ter to be deleted for a further 10 seconds.
11b) Deleting all transmitters (except master transmitter)
Press the learn button on the master trans-
mitter for 3 seconds.
Now press the learn button on the master
transmitter for a further 3 seconds.
Now press the learn button on the master
transmitter for a further 10 seconds.
12) Overwriting the master
There are 2 ways to overwrite the master transmitter:
a) Activate tubular drive programme mode by switching on the power supply
b) Activate tubular drive programme mode using the radio switch
12a) Activating the tubular drive programme mode by switching on the power supply
Motor cable
blue
Switch off the tubular drive's power supply
and switch back on after 5 seconds.
black
Note
brown
To ensure that the new master transmitter is programmed into the desired
tubular drive only, all other tubular drives which are connected to the same
green/yellow
power supply must be deactivated from the programme mode. To do so,
after switching back on the power supply, execute a control or stop
command using the transmitter for the given drives or adjust the radio
switch from the inner to the outer position. If the radio switch is already in
this position, slide the switch inwards and then back to the outer position.
Now press the learn button of the new mas-
ter transmitter for 10 seconds.
Action
The tubular drive makes a "clack" sound to
confirm.
The tubular drive makes a "clack" sound to
confirm.
The tubular drive makes a "clack-clack"
sound to confirm.
The transmitter has been deleted from the
tubular drive.
The tubular drive makes a "clack" sound to
confirm.
The tubular drive makes a "clack" sound to
confirm.
The tubular drive makes a "clack-clack"
sound to confirm.
All transmitters (except the master trans-
mitter) have been deleted from the receiver.
The tubular drive goes into programme
mode for 3 minutes.
The tubular drive makes a "clack-clack"
sound to confirm.
The new master transmitter has been
programmed and the old master transmitter
has been deleted.
25
Response