Samsung DVD-R150 Manuel De L'utilisateur page 30

DVD-Recorder Video
No Disc
Programme
TV Aspect : 16:9 Wide
Setup 3D Noise Reduction : Off
Video Output : Component
Component
RGB
HDMI/DVI Resolution : 576P
DivX(R) Registration
MOVE OK RETURN EXIT
▌ Video output
• Component : Select this when the DVD Recorder is connected to a TV with
Component jack.
• RGB : Select this when the DVD Recorder is connected to your TV using
►
SCART cable.
►
►
In Component mode, you can set video output to Progressive(P.SCAN) or
►
Interlace, see below. When the HDMI cable is not connected, available video
►
output jacks are as follow.
Setting mode
Output jack
Component Output
(Y, P , P )
B R
R, G, B
AV1 Scart
Composite
Composite Video out
S-Video out
■
When the HDMI cable is connected, other A/V output does not
operate.
Progressive scan
If the TV supports Progressive Scan, press the P.SCAN button on the front of
the DVD Recorder to enjoy.
Setting up the Progressive scan
1. With the DVD Recorder in Stop mode, press the P.SCAN button on the front
of the DVD Recorder.
The message "Press [Yes] to confi rm Progressive scan mode. Otherwise,
press [No]. " will appear.
2. Press the ◄ ► buttons to select Yes, and then press the OK button.
3. Set your TV to Progressive input (using the TV remote control.)
■
When the HDMI cable is connected, this screen is not displayed.
■
Do not press the P.SCAN button if you are using a TV that does not
support Progressive mode. Nothing will be displayed on the screen if
pressed.
■
Progressive setting is only available when the Video Out is set to
Component.
■
Progressive setting is only available when the DVD recorder is in stop
mode.
Canceling the Progressive scan
1. With the DVD Recorder in Stop mode, press the P.SCAN button on the front
of the DVD Recorder.
The message "Press [Yes] to confi rm Interlace scan mode. Otherwise, press
[No]. " will appear.
2. Press the ◄ ► buttons to select Yes, and then press the OK button.
3. Set your TV to Interlace input (using the TV remote control.)
■
If you press the P.SCAN button by mistake when your TV does not
support Progressive mode, you need to release the Progressive mode.
To release the Progressive mode, press the P.SCAN button on the front
panel 2 times.
■
The screen will recover after the PS
turns off .
English - 30
Component mode
P.SCAN off mode (Interlace mode) P.SCAN on mode
O
(TV in progressive mode)
X
O
O
O
LED on the front panel display
RGB Mode
O
X
X O
X X
X O
X O