Samsung DVD-R150 Manuel De L'utilisateur page 71

▌ Sound
No sound.
Are you watching a programme in slow or
Checkpoint 1
skip mode?
If you are playing a programme at a speed
other than normal or fast 1 speed, sound will
not be heard.
Check the connections and settings.
Checkpoint 2
(See pages 18, 28-29)
Checkpoint 3 Check whether the disc is damaged.
Clean the disc, if necessary.
Check whether the disc is inserted correctly
Checkpoint 4
with the label facing up.
No audio output.
Checkpoint 1 Check whether you have selected the correct
digital output options in the Audio Output
Options menu.
(See page 28-29.)
Timer Recording
▌
Timer lamp fl ickers.
Check there is enough space in the disc for
Checkpoint 1
recording.
Checkpoint 2 Check whether the current disc is recordable
or not.
Make sure to check before the start time of
recording.
Timer recording does not work properly.
Re-check the recording time and the end time
Checkpoint 1
settings again.
Recording will be cancelled if the power is
Checkpoint 2
interrupted due to a power failure or another
similar reason while recording.
▌ HDMI (DVD-R155 only)
No HDMI output.
Check the Video output is HDMI enabled.
Checkpoint 1
Check the connection between the TV and
Checkpoint 2
the HDMI jack of the DVD Recorder.
See if your TV supports this 576p/720p/1080i
Checkpoint 3
DVD Recorder.
Abnormal HDMI output screen.
If snow noise appears on the screen, it means
Checkpoint 1
that TV does not support HDCP
(High-bandwidth Digital Content Protection).
HDMI output Jitter
Checkpoint 1 Check your TV system setup correctly.
Checkpoint 2 Screen Jitter may occur when the frame rate is
converted from 50Hz to 60Hz for 720p/1080i
HDMI (High Defi nition Multimedia Interface)
Output.
Please refer to the user's manual of your TV.
Checkpoint 3
▌ Remote Control Unit
The remote control doesn't work.
Point the remote control at the remote control
Checkpoint 1
sensor on your DVD recorder.
Allow for proper distance. Remove obstacles
between your DVD recorder and the remote
control.
Checkpoint 2 Check whether the batteries are empty.
Checkpoint 3 Check for the TV or DVD selection button.
Other
▌
I forgot my password for parental supervision.
Checkpoint 1 Press and hold down the STOP (
on the front panel of the DVD Recorder
simultaneously for more than 5seconds with
no disc in the DVD Recorder. All settings
including the password will revert to the
factory settings.
Do not use this unless absolutely necessary.
(Note that this function is possible only when
no disc is inserted.)
Is it possible to change a subtitle and an audio signal on a
recorded disc?
A recorded disc is played with only the
Checkpoint 1
subtitle and the audio signal which were
selected during recording.
Other problems.
Read the table of contents and then fi nd and
Checkpoint 1
read the section describing your problem,
follow the instructions given.
Checkpoint 2
Turn your DVD recorder off and on.
If the problem still persists, contact a nearby
Checkpoint 3
Samsung service centre.
English - 71
) button