Publicité
Les langues disponibles
Les langues disponibles
Problem
Cause
The nozzle
is partially
blocked.
Device stops.
Blown fuse.
Active ther
mal safety.
Nozzle is par
tially blocked.
Blown fuse.
Electrical in
stallation is
to light.
Device vibrates.
Air in the wa
ter supply
hose.
Problem with
the water
supply.
The nozzle
is partially
blocked.
The water
inlet filter is
dirty.
There is a
kink in the
hose.
The device reg
Pump or jet
ularly starts and
lance are
stops by itself.
leaking.
The device
Pump, hose
starts but does
or acces
Solution
Clean the nozzle.
Contact a EUROM authorized
professional.
Allow to cool and remove the
cause of overheating.
Clean the nozzle.
Connect to an installation
with a higher amperage.
Do not use an extension ca
ble.
Allow it to escape by running
water through the device
while it is switched off.
Do not use an excessively
long or thin hose (min. 1/2".)
Clean the nozzle.
Clean the water filter.
Straighten the hose.
Have them repaired or re
placed.
Allow them to thaw and
check them.
Safety instruction
Make sure the device is off
and drained.
Do not use the device.
Make sure the device is off.
Do not use the device while
cooling off.
Make sure the device is off
and drained.
Make sure the device is off
when switching to another
electrical installation.
Make sure the device is off
when removing the exten
sion cable.
Make sure the device is off.
Make sure the device is off
and drained when changing
a hose.
Make sure the device is off
and drained.
Make sure the device is off
and drained.
Make sure the device is off.
Contact a EUROM autho
rized professional.
Do not use the device.
49
Publicité
